There was an error. Please try again.
This page is already listed in your guide. Please choose a different page to add.
Drywall Installer
Employer
Crystal Drywall CorpDate Posted
September 13, 2024Languages
English-
Location Edmonton, AB
-
Earnings $30.00 hourly
-
Work Hours 40 hours per week
-
Position Permanent Full Time
-
Vacancies 4  Vacancies
-
Closing Date Nov 12, 2024
Employer
Crystal Drywall Corp
Languages
English
Education
Secondary (high) school graduation certificate
Work setting
Various locations
Tasks
- Apply successive coats of compound and sand seams and joints
- Apply, level and smooth coats of plaster
- Cut and install metal corner beads to protect exterior corners
- Fabricate and install suspended metal ceiling grids and place in panels to form acoustical and coffered ceilings
- Fill joints, nail indentations, holes and cracks with joint compound using trowel and broad knife
- Finish corners and angles and create decorative designs in finish coat, if required
- Measure, cut, fit and install drywall sheets
- Mix plaster ingredients to desired consistency
- Mould and install ornamental plaster panels, cornices and trim
- Smooth out excess compound and allow coat to dry
- Tape over joints using taping machine and embed tape in compound
- Trowel or spray coats of stucco over exteriors of buildings to form weatherproof surfaces
- Install exterior and interior steel studs
- Install metal stud framing and furring for interior drywall or plaster walls and ceilings, using hand and power tools
- Prepare wall and ceiling layouts
Work conditions and physical capabilities
- Handling heavy loads
- Physically demanding
- Standing for extended periods
Experience
3 years to less than 5 years
Important notice: This job posting has been provided by an external employer.The Government of Alberta and the Government of Canada are not responsible for the accuracy, authenticity or reliability of the content.
Interest Codes
- METHODICAL
-
Interest in copying information to attach metal and gypsum lath to studs and furring using nails, screws, clips and wire ties
- OBJECTIVE
-
Interest in precision working to cut openings in lath for heating and ventilation piping, ducts and electrical outlets; may install acoustic tile, hangers for suspended ceilings and metal studs for composition wallboards and laths
- innovative
-
Interest in installing corner beads and wire mesh around beams for plastering
The interest code helps you figure out if you’d like to work in a particular occupation.
It’s based on the Canadian Work Preference Inventory (CWPI), which measures 5 occupational interests: Directive, Innovative, Methodical, Objective, and Social.
Each set of 3 interest codes for this NOC group is listed in order of importance.
A code in capital letters means it’s a strong fit for the occupation.
A code in all lowercase letters means the fit is weaker.
Abilities
Compared to my abilities
The abilities related to this job are shown along with your selected abilities.