Skip to the main content
This website uses cookies to give you a better online experience. By using this website or closing this message, you are agreeing to our cookie policy. More information
Alberta Supports Contact Centre

Toll Free 1-877-644-9992

Job Details

Drywall Taper

Employer

WMK CONSTRUCTION LTD

Date Posted

September 24, 2024

Languages

English
  • Location Edmonton, AB
  • Earnings $27.00 hourly
  • Work Hours 35 hours per week
  • Position Permanent Full Time
  • Vacancies 2  Vacancies
  • Closing Date Oct 24, 2024
Job Requirements

Employer

WMK CONSTRUCTION LTD

Languages

English

Education

Secondary (high) school graduation certificate

Work setting

Various locations

Tasks

  • Apply successive coats of compound and sand seams and joints
  • Cut and install metal corner beads to protect exterior corners
  • Fill joints, nail indentations, holes and cracks with joint compound using trowel and broad knife
  • Measure, cut, fit and install drywall sheets
  • Smooth out excess compound and allow coat to dry
  • Tape over joints using taping machine and embed tape in compound

Work conditions and physical capabilities

  • Bending, crouching, kneeling
  • Hand-eye co-ordination
  • Repetitive tasks

Personal suitability

  • Flexibility
  • Judgement

Experience

2 years to less than 3 years


Important notice: This job posting has been provided by an external employer.The Government of Alberta and the Government of Canada are not responsible for the accuracy, authenticity or reliability of the content.

Interest Codes & Abilities
The Drywall Taper is part of the following larger National Occupational Classification (NOC).

Interest Codes

Lathers
METHODICAL

Interest in copying information to attach metal and gypsum lath to studs and furring using nails, screws, clips and wire ties

OBJECTIVE

Interest in precision working to cut openings in lath for heating and ventilation piping, ducts and electrical outlets; may install acoustic tile, hangers for suspended ceilings and metal studs for composition wallboards and laths

innovative

Interest in installing corner beads and wire mesh around beams for plastering

Reading Interest Codes
A Quick Guide

The interest code helps you figure out if you’d like to work in a particular occupation. 

It’s based on the Canadian Work Preference Inventory (CWPI), which measures 5 occupational interests: Directive, Innovative, Methodical, Objective, and Social.

Each set of 3 interest codes for this NOC group is listed in order of importance.

A code in capital letters means it’s a strong fit for the occupation.

A code in all lowercase letters means the fit is weaker.

Learn About Interests

Learn More

Abilities

Compared to my abilities

The abilities related to this job are shown along with your selected abilities.

Typical ability expectations for this job
Selected abilities

Mental Abilities

General Learning Ability

Verbal Ability

Numerical Ability

Visual Abilities

Spatial Perception

Form Perception

Clerical Perception

Physical Abilities

Motor Coordination

Finger Dexterity

Manual Dexterity

Learn More
Was this page useful?