There was an error. Please try again.
This page is already listed in your guide. Please choose a different page to add.
Drywall Taper
Employer
Kler Drywall LtdDate Posted
November 18, 2024Languages
English-
Location Calgary, AB
-
Earnings $29.50 hourly
-
Work Hours 30 to 40 hours per week
-
Position Permanent Full Time
-
Vacancies 2  Vacancies
-
Closing Date Dec 22, 2024
Employer
Kler Drywall Ltd
Languages
English
Education
Secondary (high) school graduation certificate
Work site environment
- At heights
- Dusty
- Noisy
Work setting
- Relocation costs covered by employer
- Willing to relocate
Tasks
- Apply successive coats of compound and sand seams and joints
- Clean and prepare surfaces
- Cut and install metal corner beads to protect exterior corners
- Fill joints, nail indentations, holes and cracks with joint compound using trowel and broad knife
- Mix plaster ingredients to desired consistency
- Smooth out excess compound and allow coat to dry
- Tape over joints using taping machine and embed tape in compound
- Attach metal or gypsum lath to studs or furring
- Cut openings in lath for heating and ventilation piping, ducts and electrical outlets
- Install corner beads and wire mesh around beams to which plaster is to be applied
- Erect and install scaffolding, falsework and other working platforms
Security and safety
Criminal record check
Work conditions and physical capabilities
- Bending, crouching, kneeling
- Hand-eye co-ordination
- Manual dexterity
- Overtime required
- Physically demanding
- Repetitive tasks
- Standing for extended periods
- Work under pressure
Weight handling
Up to 23 kg (50 lbs)
Personal suitability
- Flexibility
- Reliability
- Team player
Experience
Experience an asset
Important notice: This job posting has been provided by an external employer.The Government of Alberta and the Government of Canada are not responsible for the accuracy, authenticity or reliability of the content.
Interest Codes
- METHODICAL
-
Interest in copying information to attach metal and gypsum lath to studs and furring using nails, screws, clips and wire ties
- OBJECTIVE
-
Interest in precision working to cut openings in lath for heating and ventilation piping, ducts and electrical outlets; may install acoustic tile, hangers for suspended ceilings and metal studs for composition wallboards and laths
- innovative
-
Interest in installing corner beads and wire mesh around beams for plastering
The interest code helps you figure out if you’d like to work in a particular occupation.
It’s based on the Canadian Work Preference Inventory (CWPI), which measures 5 occupational interests: Directive, Innovative, Methodical, Objective, and Social.
Each set of 3 interest codes for this NOC group is listed in order of importance.
A code in capital letters means it’s a strong fit for the occupation.
A code in all lowercase letters means the fit is weaker.
Abilities
Compared to my abilities
The abilities related to this job are shown along with your selected abilities.